Indoor Load break switch, normally used for RMU. Ring main unit is used in a secondary distribution system. It is basically used for an uninterrupted power supply. Alongside, it also protects your secondary side transformer from the occasional transient currents.
This series of products is divided into: ordinary type and cast aluminum type according to the fuel tank material.
This series of voltage transformers can provide five-coil products according to customer requirements.
This type of transformer is a single-phase three-winding series insulation, outdoor installation, suitable for voltage supply, electric energy measurement and relay protection in 50Hz, 66kV neutral point non-effectively grounded systems.
This series of voltage transformers can provide five-coil products according to customer requirements.
Capacitive voltage transformers are widely used in AC power systems for measurement, control, protection and high-frequency carrier communication.
This series of voltage transformers can provide five-coil products according to customer requirements.
GN19-12 indoor high-voltage isolating switch is a high-voltage switching device, used in power systems with a rated voltage of 12kV, AC 50Hz and below.
GN30-12 indoor rotary high-voltage isolating switch is a new type of rotary contact knife isolating switch.
GN27 (GN2)-40.5 indoor high-voltage isolating switch is a three-phase AC 50Hz high-voltage switching device.
GN27 (GN2)-40.5 indoor high-voltage isolating switch is a three-phase AC 50Hz high-voltage switching device.
Copyright © 2021 By JGGY Electrical.com